Ensurepass QUESTION 351 Router E is configured with the EIGRP variance 2 command. What path will Router E take to reach Router A? A. only E-D-A B. only E-B-A C. only E-C-A D. both E-B-A and E-C-A E. both E-B-A and E-D-A F. all available paths. Correct Answer: D Read more […]
642-902 practice test
Latest 642-902 Pass4sure Free Tests 341-350
Ensurepass QUESTION 341 Which three steps are most helpful in verifying proper route redistribution? (Choose three.) A. On the routers not performing the route redistribution, use the show ip route command to see if the redistributed routes show up. B. On the ASBR router performing the route redistribution, use the show ip protocol command to verify the redistribution configurations. C. Read more […]
Latest 642-902 Pass4sure Free Tests 331-340
Ensurepass QUESTION 331 A network administrator would like to configure an EIGRP router as a stub router that advertises directly connected and summary routes only. What command must the administrator issue to accomplish this? A. eigrp stub B. eigrp stub connected C. eigrp stub summary D. eigrp stub connected static E. Read more […]
Latest 642-902 Pass4sure Free Tests 321-330
Ensurepass QUESTION 321 What two features are benefits of using GRE tunnels with IPsec over using IPsec tunnel alone for building site-to-site VPNs? (Choose two.) A. allows dynamic routing securely over the tunnel B. IKE keepalives are unidirectional and sent every ten seconds C. reduces IPsec headers overhead since tunnel mode is used D. supports Read more […]
Latest 642-902 Pass4sure Free Tests 311-320
Ensurepass QUESTION 311 Refer to the exhibit. ROUTE.com is planning to implement load balancing for traffic between hosts on the 172.16.10.0/24 and 172.16.20./24 networks. You have been asked to review the implementation plan for this project. Which statement about the plan is true? A. It is complete as written. B. It should include a task to configure EIGRP multipath equal to 2 on R1 and R4. C. Read more […]
Latest 642-902 Pass4sure Free Tests 301-310
Ensurepass QUESTION 301 In EIGRP, when the IP default-network command is configured on a router, what is generated in the router’s configuration? A. A static route B. A directly connected route C. An EIGRP route D. A default route Correct Answer: A QUESTION 302 Refer to the exhibit. OSPF is running throughout the network Read more […]
Latest 642-902 Pass4sure Free Tests 291-300
Ensurepass QUESTION 291 Refer to the Exhibit. Routers in the Diagram are configured with EIGRP. If RTB and RTC fail, which action will RTA take with respect to the HQ network? A. RTA will automatically route packets via RTD to the HQ network. B. RTA will place the route via RTD into the hold down state. C. RTA will go into the active state for all routers. D. Read more […]
Latest 642-902 Pass4sure Free Tests 281-290
Ensurepass QUESTION 281 Click and drag the associated EIGRP functionality on the left to the corresponding topology characteristic on the right. Correct Answer: QUESTION 282 Which two statements about 6to4 tunneling are accurate? (Choose two.) A. Prepending a reserved IPv6 code to the hexadecimal representation of 192.168.0.1 facilitates 6to4 tunneling. B. Each 6to4 site receives a /48 prefix Read more […]
Latest 642-902 Pass4sure Free Tests 271-280
Ensurepass QUESTION 271 When policy-based routing (PBR) is being configured, which three criteria can the set command specify? (Choose three.) A. all interfaces through which the packets can be routed B. all interfaces in the path toward the destination C. adjacent next hop router in the path toward the destination D. all routers in the path toward the destination E. all networks in the path toward the destination F. type of service and precedence Read more […]
Latest 642-902 Pass4sure Free Tests 261-270
Ensurepass QUESTION 261 An IPv6 overlay tunnel is required to communicate with isolated IPv6 networks across an IPv4 infrastructure. There are currently five IPv6 overlay tunnel types. Which three IPv6 overlay tunnel statements are true? (Choose three.) A. Overlay tunnels can only be configured between border routers capable of supporting IPv4 and IPv6. B. Overlay tunnels can be configured between border routers Read more […]
Latest 642-902 Pass4sure Free Tests 251-260
Ensurepass QUESTION 251 Refer to the exhibit. Which two statements are correct regarding the routes to be redistributed into OSPF? (Choose two.) A. The network 192.168.1.0 will be allowed and assigned a metric of 100. B. The network 192.168.1.0 will be allowed and assigned a metric of 200. C. All networks except 10.0.0.0/8 will be allowed and assigned a metric of 200. D. The network 172.16.0.0/16 will be allowed and assigned a metric of 200. E. The Read more […]
Latest 642-902 Pass4sure Free Tests 241-250
Ensurepass QUESTION 241 Which statement describes the difference between a manually configured IPv6 in IPv4 tunnel versus an automatic 6to4 tunnel? A. A manually configured IPv6 in IPv4 tunnel allows multiple IPv4 destinations. B. An automatic 6to4 tunnel allows multiple IPv4 destinations. C. A manually configured IPv6 in IPv4 tunnel does not require dual-stack (IPv4 and IPv6) Read more […]
Latest 642-902 Pass4sure Free Tests 231-240
Ensurepass QUESTION 231 To enable BGP tunneling over an IPv4 backbone, the IPv4 address 192.168.30.1 is converted into a valid IPv6 address. Which three IPv6 addresses are acceptable formats for the IPv4 address? (Choose three.) A. 192.168.30.1:0:0:0:0:0:0 B. 0:0:0:0:0:0:192.168.30.1 C. ::192.168.30.1 D. C0A8:1E01:: E. Read more […]
Latest 642-902 Pass4sure Free Tests 221-230
Ensurepass QUESTION 221 When an IPv6 enabled host boots, it sends a router solicitation (RS) message. An IPv6 router responds with a router advertisement (RA). Which two items are contained in the RA? (Choose two.) A. IPv6 address for the host B. lifetime of the prefix C. prefixes for the link D. keepalive timers E. Read more […]
Latest 642-902 Pass4sure Free Tests 211-220
Ensurepass QUESTION 211 What happens when an IPv6 enabled router running 6to4 must send a packet to a remote destination and the next hop is the address of 2002::/16? A. The IPv6 packet has its header removed and replaced with an IPv4 header B. The IPv6 packet is encapsulated in an IPv4 packet using an IPv4 protocol type of 41 C. The IPv6 packet is dropped because that destination Read more […]
Latest 642-902 Pass4sure Free Tests 201-210
Ensurepass QUESTION 201 What technique should be used on BGP edge routers to prevent a multi-homed autonomous system from becoming a transit system? A. Advertise with a high MED value all networks that are discovered via external BGP. B. Set the no-export community attribute on all networks that are advertised externally. C. Remove the AS-Path information on all routes in the BGP table prior to Read more […]
Latest 642-902 Pass4sure Free Tests 191-200
Ensurepass QUESTION 191 Which two statements are true about IBGP neighbor relationships? (Choose two.) A. An EGP or static routing is required between IBGP neighbors. B. A full-mesh IBGP requires that neighbor relationships be established between all BGP enabled routers in the autonomous system. C. IBGP neighbors must be in different autonomous systems. D. Read more […]
Latest 642-902 Pass4sure Free Tests 181-190
Ensurepass QUESTION 181 Above is the output from show ip bgp neighbors command. What is line 21 stating about the BGP connection? A. the number of neighbors that the router has B. the number of times the router has established a TCP connection C. the number of consecutive TCP connections to the specified remote neighbor D. the number of total TCP Read more […]
Latest 642-902 Pass4sure Free Tests 171-180
Ensurepass QUESTION 171 Refer to the exhibit. Router RT-1 chooses one path to network 198.133.219.0/24. Indicate the reason Router RT-1 chooses this “best” path. A. In making its decision about the best path, RT-1 gives precedence to the origin code. B. In making its decision about the best path, RT-1 gives precedence to the BGP MED values. C. IP address 128.107.2.2 is lower Read more […]
Latest 642-902 Pass4sure Free Tests 161-170
Ensurepass QUESTION 161 Based on the show ip bgp summary output. Which two statements are true? (Choose two.) A. The BGP session to the 10.1.1.1 neighbor is established. B. The BGP session to the 10.2.2.2 neighbor is established. C. The BGP session to the 10.3.3.3 neighbor is established. D. The router is attempting to establish a BGP peering session with the 10.1.1.1 neighbor. E. The BGP session to the 10.3.3.3 neighbor is established, but the router has Read more […]