2013 LATEST 350-001 PASS4SURE FREE TESTS 421-430

Ensurepass  QUESTION 421 Which two statements are true about LACP? (Choose two.)   A.       LACP packets are sent with multicast group MAC address 01-80-c2-00-00-02. B.       The Type/Field value is 0x8808. C.       During detection, LACP packets are transmitted every second. D.      The timeout for a failed LACP channel is 30 seconds by default.   Correct Answer: AC   Read more […]

Continue reading


2013 LATEST 350-001 PASS4SURE FREE TESTS 411-420

Ensurepass  QUESTION 411 Which value should be used in the configuration register of a router in order to boot into bootstrap?   A.       0x2102 B.       0x2142 C.       0x2124 D.      0x2101   Correct Answer: D     QUESTION 412 Refer to the exhibit.   R1 has two eBGP sessions to ISP1 and ISP2 (one to each ISP router), and R1 receives the same prefixes Read more […]

Continue reading


2013 LATEST 350-001 PASS4SURE FREE TESTS 401-410

Ensurepass  QUESTION 401 Which statement is true of a source that wants to transmit multicast traffic to group 239.1.1.1?   A.       Before sending traffic, it must first join multicast group 239.1.1.1 by sending an IGMPv2 membership report to the default router on the local subnet. B.       It must send an IGMPv2 Request to Send packet and then wait for an IGMPv2 Clear to Send packet from the IGMPv2 querier router on the local Read more […]

Continue reading


2013 LATEST 350-001 PASS4SURE FREE TESTS 391-400

Ensurepass  QUESTION 391 This question is about the formation of OSPF adjacency. An OSPF adjacency will not form correctly across a point-to-point link in the same area. Which would most likely cause this problem?   A.       Each interface has a different OSPF cost. B.       Each interface is configured with secondary addresses as well as primary addresses. C.       Each interface has a different MTU Read more […]

Continue reading


2013 LATEST 350-001 PASS4SURE FREE TESTS 381-390

Ensurepass  QUESTION 381 You are a network technician, study the exhibit carefully. In this EIGRP network, the output of the command show interface for the link between R2 and R5 indicates that the link load varies between 10 and 35. Which K value setting will be used to make sure that this link is not used by EIGRP when the link load reaches 35, but can be used again when the link load drops below 20?   A.  Link load is not read in real time, so there is no way to set the K values Read more […]

Continue reading


2013 LATEST 350-001 PASS4SURE FREE TESTS 371-380

Ensurepass  QUESTION 371 Which two steps below should you perform on the hub router while configuring EIGRP routing over DMVPN (mGRE tunnel)? (Choose two.)   A.       Set the NHRP hold time to match the EIGRP hold time B.       Add the enable eigrp stub command C.       Add the disable eigrp as-member split-horizon command D.      Add the disable eigrp as-member next-hop-self Read more […]

Continue reading


2013 LATEST 350-001 PASS4SURE FREE TESTS 361-370

Ensurepass  QUESTION 361 Internet Protocol version 6 (IPv6) is the next-generation Internet Layer protocol for packet- switched internetworks and the Internet. IPv6 router solicitation is:   A.       A request made by a node for the IP address of the local router B.       A request made by a node to join a specified multicast group C.       A request made by a node for a DHCP provided IP address D.      Read more […]

Continue reading


2013 LATEST 350-001 PASS4SURE FREE TESTS 351-360

Ensurepass  QUESTION 351 Which three statements are true about Source Specific Multicast? (Choose three.)   A.       Is best suited for applications that are in the one-to-many category. B.       SSM uses shortest path trees only. C.       The use of SSM is recommended when there are many sources and it is desirable to keep the amount of mroute state in the routers in the network to a D.      Read more […]

Continue reading


2013 LATEST 350-001 PASS4SURE FREE TESTS 341-350

Ensurepass  QUESTION 341 What are the mandatory, well-known BGP attributes?   A.       origin, AS-path, next-hop B.       AS-path, origin, MED C.       AS-path, origin, weight D.      AS-path, weight, MED   Correct Answer: A     QUESTION 342 Network A has a spanning-tree problem in which the traffic is selecting a longer path. How is the path cost calculated? Read more […]

Continue reading


2013 LATEST 350-001 PASS4SURE FREE TESTS 331-340

Ensurepass  QUESTION 331 Which of the following describes the appropriate port assignment and message exchange in a standard TFTP transaction?   A.  Server: 10.0.0.1:69 RRQ/WRQ Sent     Client: 10.0.0.2:1888 RRQ/WRQ Received   B.  Server: 10.0.0.1:1888 RRQ/WRQ Received     Client: 10.0.0.2:69 RRQ/WRQ Received   C.  Server: 10.0.0.1:69 RRQ/WRQ Received     Client: 10.0.0.2:69 RRQ/WRQ Sent   D.  Server: 10.0.0.1:69 Read more […]

Continue reading


2013 LATEST 350-001 PASS4SURE FREE TESTS 321-330

Ensurepass  QUESTION 321 Refer to the exhibit. According to the output of the command show tag-switching forwarding-table, which four of these statements are true? (Choose four.)   A.       Packets to the IP address 10.10.10.5/32 will be tagged with “17” toward the next hop. B.       Label “19” will be advertised to MPLS neighbors so that they can use this label to reach the IP address 10.10.10.6/32. C.       Read more […]

Continue reading


2013 LATEST 350-001 PASS4SURE FREE TESTS 311-320

Ensurepass  QUESTION 311 Before inserting a new switch in the network, the network administrator checks that the VTP domain name is correct, the VTP mode is set to server, and revision is lower than the switches in the network. The administrator then configures interfaces and trunks, erases existing VLANs, and connects the switch to the network. Following that procedure, there is no connectivity in the network. What is a possible cause of this problem?   A.       Read more […]

Continue reading


2013 LATEST 350-001 PASS4SURE FREE TESTS 301-310

Ensurepass  QUESTION 301 A request arrived on your MPLS-vpn-bgp group. Due to a security breach, your customer is experiencing DoS attacks coming from specific subnets (200.0.10.0/24, 200.0.12.0/24). You have checked all MPLS- EBGP routes being advertised to BHK from other VPN sites and found four subnets listed: 200.0.10.0/24, 200.0.11.0/24, 200.0.12.0/24, 200.0.13.0/24. You immediately apply an outbound ACL filter using the appropriate MPLS-EBGP tool: access-list 1 deny 200.0.10.0 255.255.254.0 Read more […]

Continue reading


2013 LATEST 350-001 PASS4SURE FREE TESTS 291-300

Ensurepass  QUESTION 291 The core of a network has four routers connected in a square design with Gigabit Ethernet links using /30 subnets. The network is used to carry voice traffic and other applications. Convergence time is taking more than expected. Which three actions would you take to improve OSPF convergence time? (Choose three.)   A.       Increase MTU of the interfaces to accommodate larger OSPF packets B.       Change Read more […]

Continue reading


2013 LATEST 350-001 PASS4SURE FREE TESTS 281-290

Ensurepass  QUESTION 281 Two BGP peers connected through a routed firewall are unable to establish a peering relationship. What could be the most likely cause?   A.       BGP peers must be Layer 2-adjacent. B.       EBGP multihop is not configured. C.       The firewall is not configured to allow IP protocol 89. D.      The firewall is not configured to allow UDP 179.   Read more […]

Continue reading


2013 LATEST 350-001 PASS4SURE FREE TESTS 271-280

Ensurepass  QUESTION 271 You are designing your network to be able to use trunks. As part of this process you are comparing the ISL and 802.1 Q encapsulation options. All of these statements about the two encapsulation options are correct except which one?   A.       Both support normal and extended VLAN ranges. B.       ISL is a Cisco proprietary encapsulation method and 802.1 Q is an IEEE standard. C.       Read more […]

Continue reading


2013 LATEST 350-001 PASS4SURE FREE TESTS 261-270

Ensurepass  QUESTION 261 Which of these tables is used by an LSR to perform a forwarding lookup for a packet destined to an address within an RFC 4364 VPN?   A.       CEF B.       FIB C.       LFIB D.      IGP   Correct Answer: C     QUESTION 262 Which two of these parameters are used to determine a forwarding equivalence class? (Choose two.)   A.  Read more […]

Continue reading