Download New Updated (Spring 2015) Cisco 200-101 Actual Tests 201-210

Ensurepass  QUESTION 201 Which three statements about VTP features are true? (Choose three.)   A.       VTP works at Layer 3 of the OSI model and requires that a management VLAN IP address be configured. B.        When properly configured, VTP minimizes VLAN misconfigurations and configuration inconsistencies. C.        When properly configured, VTP maintains VLAN configuration consistency Read more […]

Continue reading


Download New Updated (Spring 2015) Cisco 200-101 Actual Tests 211-220

Ensurepass  QUESTION 211 Refer to the exhibit. A technician pastes the configurations in the exhibit into the two new routers shown. Otherwise, the routers are configured with their default configurations. A ping from Host1 to Host2 fails, but the technician is able to ping the S0/0 interface of R2 from Host1. The configurations of the hosts have been verified as correct. What could be the cause of the problem?     A.       The serial cable on R1 needs Read more […]

Continue reading


Download New Updated (Spring 2015) Cisco 200-101 Actual Tests 171-180

Ensurepass  QUESTION 171 Which command enables IPv6 forwarding on a Cisco router?   A.       ipv6 local B.        ipv6 host C.        ipv6 unicast-routing D.       ipv6 neighbor   Correct Answer: C     QUESTION 172 When using the CLI, which banner displays a message upon every connection that is made into the router?   A.      Read more […]

Continue reading


Download New Updated (Spring 2015) Cisco 200-101 Actual Tests 181-190

Ensurepass  QUESTION 181 What is one benefit of PVST+?   A.       PVST+ supports Layer 3 load balancing without loops. B.        PVST+ reduces the CPU cycles for all the switches in the network. C.        PVST+ allows the root switch location to be optimized per VLAN. D.       PVST+ automatically selects the root bridge location, to provide optimized bandwidth Read more […]

Continue reading


Download New Updated (Spring 2015) Cisco 200-101 Actual Tests 161-170

Ensurepass  QUESTION 161 Which name describes an IPv6 host-enabled tunneling technique that uses IPv4 UDP, does not require dedicated gateway tunnels, and can pass through existing IPv4 NAT gateways?   A.       manual 6to4 B.        dual stack C.        dynamic D.       Teredo   Correct Answer: D     QUESTION 162 What is the default maximum number Read more […]

Continue reading


Download New Updated (Spring 2015) Cisco 200-101 Actual Tests 151-160

Ensurepass  QUESTION 151 Which two states are the port states when RSTP has converged? (Choose two.)   A.      blocking B.      listening C.      learning D.      forwarding E.       disabled   Correct Answer: AD     QUESTION 152 Which two statistics appear in show frame-relay map output? (Choose two.)   A.       Read more […]

Continue reading


Download New Updated (Spring 2015) Cisco 200-101 Actual Tests 131-140

Ensurepass  QUESTION 131 Refer to the exhibit. A technician is testing connection problems in the internetwork. What is the problem indicated by the output from HostA?     A.       The routing on Router2 is not functioning properly. B.        An access list is applied to an interface of Router3. C.        The Fa0/24 interface of Switch1 is down. D.       Read more […]

Continue reading


Download New Updated (Spring 2015) Cisco 200-101 Actual Tests 120-130

Ensurepass  QUESTION 121 Refer to the graphic. A company wants to use NAT in the network shown. Which commands will apply the NAT configuration to the proper interfaces? (Choose two.)   A.       R1(config)# interface serial0/1 R1(config-if)# ip nat inside   B.        R1(config)# interface serial0/1 R1(config-if)# ip nat outside   C.        R1(config)# interface fastethernet0/0 Read more […]

Continue reading


Download New Updated (Spring 2015) Cisco 200-101 Actual Tests 101-110

Ensurepass  QUESTION 101 Which two of these statements regarding RSTP are correct? (Choose two.)   A.       RSTP cannot operate with PVST+. B.        RSTP defines new port roles. C.        RSTP defines no new port states. D.       RSTP is a proprietary implementation of IEEE 802.1D STP. E.        RSTP is compatible with the Read more […]

Continue reading


Download New Updated (Spring 2015) Cisco 200-101 Actual Tests 111-120

Ensurepass  QUESTION 111 The internetwork infrastructure of company XYZ consists of a single OSPF area as shown in the graphic.   There is concern that a lack of router resources is impeding internetwork performance. As part of examining the router resources, the OSPF DRs need to be known. All the router OSPF priorities are at the default and the router IDs are shown with each router. Which routers are likely to have been elected as DR? (Choose two.)   A.       Read more […]

Continue reading


Download New Updated (Spring 2015) Cisco 200-101 Actual Tests 91-100

Ensurepass  QUESTION 91 What command is used to verify the DLCI destination address in a Frame Relay static configuration?   A.      show frame-relay pvc B.      show frame-relay lmi C.      show frame-relay map D.      show frame relay end-to-end   Correct Answer: C     QUESTION 92 The output of the show frame-relay pvc command shows “PVC STATUS = INACTIVE”. What does this Read more […]

Continue reading


Download New Updated (Spring 2015) Cisco 200-101 Actual Tests 71-80

Ensurepass HOT EXAM! 100-105 Dumps VCE PDF 200-105 Dumps VCE PDF 300-101 Dumps VCE PDF 300-115 Dumps VCE PDF 300-135 Dumps VCE PDF 300-320 Dumps VCE PDF 400-101 Dumps VCE PDF 640-911 Dumps VCE PDF 640-916 Dumps VCE PDF 70-410 Dumps VCE PDF 70-411 Dumps VCE PDF 70-412 Dumps VCE PDF 70-413 Dumps VCE PDF 70-414 Dumps VCE PDF 70-417 Dumps VCE PDF 70-461 Dumps VCE PDF 70-462 Dumps VCE PDF 70-463 Dumps VCE PDF 70-464 Dumps VCE PDF 70-465 Dumps VCE PDF 70-480 Dumps VCE PDF 70-483 Read more […]

Continue reading


Download New Updated (Spring 2015) Cisco 200-101 Actual Tests 81-90

Ensurepass  QUESTION 81 At which layer of the OSI model does PPP perform?   A.      Layer 2 B.      Layer 3 C.      Layer 4 D.      Layer 5   Correct Answer: A     QUESTION 82 The command show frame-relay map gives the following output:   Serial 0 (up): ip 192.168.151.4 dlci 122, dynamic, broadcast, status defined, active   Which statements represent what is shown? Read more […]

Continue reading


Download New Updated (Spring 2015) Cisco 200-101 Actual Tests 51-60

Ensurepass  QUESTION 51 Which type of EIGRP route entry describes a feasible successor?   A.      a backup route, stored in the routing table B.      a primary route, stored in the routing table C.      a backup route, stored in the topology table D.      a primary route, stored in the topology table Correct Answer: C     QUESTION 52   Correct Answer:     QUESTION Read more […]

Continue reading


Download New Updated (Spring 2015) Cisco 200-101 Actual Tests 61-70

Ensurepass  QUESTION 61   OSPF is configured using default classful addressing. With all routers and interfaces operational, how many networks will be in the routing table of R1 that are indicated to be learned by OSPF?   A.      2 B.      3 C.      4 D.      5 E.       6 F.       7   Correct Answer: C     QUESTION Read more […]

Continue reading


Download New Updated (Spring 2015) Cisco 200-101 Actual Tests 41-50

Ensurepass  QUESTION 41 The internetwork infrastructure of company XYZ consists of a single OSPF area as shown in the graphic. There is concern that a lack of router resources is impeding internetwork performance. As part of examining the router resources, the OSPF DRs need to be known. All the router OSPF priorities are at the default and the router IDs are shown with each router. Which routers are likely to have been elected as DR? (Choose two.)     A.      Read more […]

Continue reading